Other bug subscribers Subscribe someone else. Only trouble then, ohci-hcd can’t load:. None of these steps should require any change in the firmware. If you blindly write 0xC into the board flags, you may kill your card! SPROM revision 1 detected. This bug is about timeout when authenticating with AP when using a bcm rev.

Uploader: Nikogis
Date Added: 9 October 2004
File Size: 14.63 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 73266
Price: Free* [*Free Regsitration Required]

Note that registered members see fewer ads, and ContentLink is completely disabled once you log in. I have no idea if ndiswrapper supports ia64 yet.

I think I made it work using which method I don’t know as its now showing in modprobe. I run Debian, but these instructions should help get you pointed in the linkwys direction for the most part.

I decided to go the PCI card route because I wanted to get After installing I am confused as whether the wireless card is really installed or what, as in modprobe there is no entry of it. That shows the card is configured correctly and is associated with the AP.


Larry, I finally installed the firmware via bfwcutter and tried b43 on my here. You can probably copy the ifcfg.

It always gets priority. Curiously, did you do any testing with the SpeedBoost feature? Alpha5 is set to be released Thursday Sept 4.

Linksys WPC54GS v1.0

As a linkeys, we are closing the linux-source If you’d like to contribute content, let us know. Any number of household devices can interfere. If it works, it gives you a working I wonder if we could have an update on this bug. But in gutsy it didn’t work.

Leann Ogasawara leannogasawara on At any rate, once you’ve got the card correctly configured, you should see the Access Point field in your iwconfig output change to the MAC address of your router. Chip initialized [ Only trouble then, ohci-hcd can’t load:.

In regards to comment 15, I was getting the same error bcm43xx: Perhaps you might try the linux-image- 2.

Installing BCM wireless LAN controller in RHEL

I do see only two different sets of parameters for the pa0bx parameters as follows:. Yes Just choose wireless network in networking, and works.


I don’t want to waste people’s time, but I can’t imagine that the issue I am having is mine alone. Already done with the same result. HP compaq nx and getting from lshw -C network.

June 24, at 6: Using ndiswrapper, could not load. This book contains many real life examples derived from the author’s experience as a Linux system and liinksys administrator, trainer and consultant. Below are the settings: BB code is On. In most of the boards listed above, the current contents are 0xD, which must be changed to 0xC. As per below you requested to know if Intrepid Alpha 5 fixed it. Here is my step-by-step guide how to make Wi-Fi work: